Flowserve VCT Instrukcja Użytkownika

® Pump Division Model: VCT VERTICAL CENTRIFUGAL PUMPS USER INSTRUCTIONS: INSTALLATION, OPERATION AND MAINTENANCE for sel

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 10 of 32 ®and as in consequence, catastrophic failure to the top parts of the motor. If the

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 11 of 32 ®d) Check outlet pressure. e) Check outlet capacity. f) Check vibration at r

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 12 of 32 ®procedure for shutting down the machine is followed, as described in section

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 13 of 32 ® Refer to the manuals of any associated equipment for periodic checks need

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 14 of 32 ®Bolt size Torque Nm (lbft) M 16 (⅝ in.) 84 (62) M 20 (¾ in.) 165 (120) M 24

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 15 of 32 ® NOTE As outer column (1350) is being removed from upper

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 16 of 32 ®3. Journal sleeves (3420). Inspect journal sleeves. If journal sleeves are worn, t

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 17 of 32 ®e) Using eyebolts with washer/nuts (not provided), rig casing (1170) upper fl

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 18 of 32 ® 7 FAULTS; CAUSES AND REMEDIES Trouble Cause Remedy Insufficient Capacity S

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 19 of 32 ®8 PARTS LIST AND DRAWINGS 8.1 Typical sectional drawing

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 2 of 32 ® CONTENTS PAGE 1 INTRODUCTION AND SAFETY 3 1.1 General…………………………..

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 20 of 32 ®8.1.1 Stuffing box typical sectional drawing

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 21 of 32 ®8.1.2 Coupling assembly drawing

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 22 of 32 ®8.1.3 Coupling assembly with spacer drawing

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 23 of 32 ® 8.1.4 Discharge typical sectional drawing

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 24 of 32 ® 8.1.5 Typical cross sectional drawing of multistage pump

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 25 of 32 ® 8.1.6 Suction bell with bearing When suction bell bearing is provided, it is p

8.2 Parts list 8.3 General arrangement drawing The typical general arrangement drawing and any specific drawings required by the contract w

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 27 of 32 ® 10 SUPPLEMENTARY INFORMATION 10.1 Long term storage During extended peri

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 28 of 32 ®INSPECTION UPON ARRIVAL When the pump is received, it should be inspected

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 29 of 32 ®depending upon the inspection reports being favorable or unfavorable, ins

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 3 of 32 ®1 INTRODUCTION AND SAFETY 1.1 General These instructions must always be k

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 30 of 32 ® If pump must be stored in a wet pit, the following inspection and maintenance pro

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 31 of 32 ®gauges and a micrometer. Small wooden wedges can be inserted between the shaft an

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 32 of 32 ®

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 33 of 32 ®10.4 CUSTOMER SERVICE INFORMATION SANTA CLARA OPERATION Personal Assistence.

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 34 of 32 ®

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 4 of 32 ® This symbol indicates electrical safety instructions where non-compliance

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 5 of 32 ® LIFTING DEVICES Mounted on individual parts are intended for lifting the individu

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 6 of 32 ®2.1 Consignment receipt and unpacking Immediately after receipt of the equipment i

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 7 of 32 ® Fully trained personnel must carry out lifting, in accordance with local regul

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 8 of 32 ®with ample headroom for lifting it. Refer to the general arrangement drawin

USER INSTRUCTIONS APM, APMA and APH MX0301 - 07/03 Page 9 of 32 ®4.6 Piping Protective covers are fitted to the discharge flange, pipe co