Flowserve GCX Series Instrukcja Użytkownika Pobierz pdf (Strona 3)

1.5 Check equipment dimensions to ensure that they are within the

specications shown in Figures 1, 2, and 3. Critical dimensions

from Figure 2 include:

• Box Bore (dim ØC)

• Box Depth (dim G)

• Distance to First Obstruction (dim K)

• Pump Frame accommodates Gland OD (dim E)

1.6 Check gland bolting to ensure that bolt diameter and bolt circle

conform to the dimensions shown in Figure 2 and 3. (dims C & M)

1.7 Handle the GCX with care, it is manufactured to precise tolerances.

The sealing faces of the GCX seal are the stationary face and the

rotating face. They are lapped at to within three helium light bands

(34.8 millionths of an inch). Keep the seal faces perfectly clean at

all times.

Seal Chamber Requirements Figure 1

To first obstruction

Face of seal housing to be square to the axis

of the shaft to within 0.013 mm per millimeter

(0.0005 inches) of seal chamber bore FIM and

have a √1.6

μm (63 μinch) R finish or better

Gland pilot can be at either of these

0.13 mm (0.005 inch) FIM of shaft or sleeve OD

Seal housing bore to have √3.2 μm

(125 μinch) R finish or better

Sleeve or shaft finish to be

0.8 μm (32 μinch) R or better

Shaft or sleeve OD

+0.000 mm (+0.000 inch)

-0.050 mm (-0.002 inch) ANSI

+0.000 mm (+0.000 inch) API 610/682

-0.025 mm (- 0.001 inch) DIN/ISO

• Bearings must be in good condition

• Maximum lateral or axial movement of shaft (end play) = 0.25 mm (0.010 inch) FIM

• Maximum shaft runout at face of seal housing = 0.05 mm (0.002 inch) FIM

• Maximum dynamic shaft deflection at seal housing = 0.05 mm (0.002 inch) FIM

1 2 3 4 5 6 7 8 ... 11 12

Brak uwag

Flowserve GCX Series Instrukcja Użytkownika Strona 3