Flowserve MSS Series Instrukcja Użytkownika Pobierz pdf (Strona 3)

Notice: Cleanliness during installation is crucial to the satisfactory

operation of the MSS seal.

Caution: Installation of this seal requires the use of an adhesive to bond

the O-ring secondary seals together. Do not allow the

adhesive to come in contact with skin.

There are two basic models of the MSS seal, Piloted, see Figure 2,

page 4, and Non-Piloted, see Figure 3, page 8.

Seal Chamber Requirements Figure 1

Face of seal housing to be square to the

axis of the shaft to within 0.5 mm (.020 inch)

FIM and have a 1.6 mm (63√ m inch) R

nish or better

Sleeve or

shaft nish

to be 0.8 mm

(32√ m inch)

or better

Shaft or Sleeve

OD ±.02 mm

(±.001 inch)

• Bearings must be in good condition

• Maximum axial movement of shaft (end play) = 0.25 mm (0.010inch) FIM

• Maximum combined shaft eccentricity and shaft deection at face of housing

total = 3.8 mm (0.150 inch) FIM

First

Obstruction

1 2 3 4 5 6 7 8 ... 11 12

Brak uwag

Flowserve MSS Series Instrukcja Użytkownika Strona 3