Flowserve QX Limitorque Instrukcja Użytkownika Strona 53

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 82
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 52
53
Limitorque QX Electronic Actuator FCD LMENIM3314-00 – 5/11
flowserve.com
Note: The encoder rotor can only be mated to the encoder shaft in one position. The encoder shaft has 3 flats that
must align correctly to the encoder rotor ID and ribs. See Figure 5.3 for reference.
Step 4
Install the three M4 screws thru encoder and standoff assembly (#17-6) and tighten. Take note not to over tighten.
Step 5
Reconnect encoder ribbon cable to motor controller board. (See section 6 for connector position on motor control
board).
Przeglądanie stron 52
1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 81 82

Komentarze do niniejszej Instrukcji

Brak uwag