Flowserve SLC Series Interseal Instrukcja Użytkownika Pobierz pdf (Strona 9)

5.5 For adapters provided with a centering jig, simply insert the centering jig into the

adapter and tighten adapter bolts, alternately adjusting the cover location until

the centering jig can be removed by hand.

5.6 Dial indicate front face of seal t on the adapter plate. This t must be perpen-

dicular to the shaft within 0.25 mm (0.010 inch) FIM (TIR). See Figure 12. If

surface is out of tolerance, correct by machining the faces of the locating ts. Be

sure to have all ts clean of dirt, rust and/or paint.

Adapter Plate Mounting Surface Perpendicular to Shaft Figure 12

Adapter Mounting Surface to be

Perpendicular to Shaft within

0.25 mm (0.010 inch) FIM (TIR)

5.7 If seal is directly mounted on shaft and not on the equipment sleeve, install

impeller spacer hook sleeve (possibly modied) and impeller.

5.8 Slide seal ange/gland towards adapter to engage into the locating bore of the

adapter plate. Insert retaining bolts through ange/gland holes and screw into

front face of the adapter plate. Evenly tighten retaining bolts to pull the seal up to

the adapter t. See Figure 13.

Bolt Cartridge to Adapter Plate Face Figure 13

1 2 3 4 5 6 7 8 9 10 11 12

Brak uwag

Flowserve SLC Series Interseal Instrukcja Użytkownika Strona 9