Flowserve PMV D3 Digital Positioner Instrukcja Użytkownika Pobierz pdf (Strona 41)

Transmitter board installation

Caution! Turn off the power and air

supply starting the installation.

Important for D3 Intrinsically safe units:

Transmitter boards NOT for on site

mounting by customer. FM, CSA and

ATEX certificate only valid when trans-

mitter board is mounted by manufacturer.

• Remove the cover, indicator and inner

cover according to the description on page

37.

• Check that both spacers C are installed.

• Carefully mount the circuit board in its

position. The pins D should fit in the

connector and the positioners motherboard.

Make sure that the feed back PC board is

properly connected.

• Secure the circuit board with the enclosed

screws E.

• Install the cam asssembly B on the shaft

and push it down to its position. If the board

has microswitches, be careful not to damage

the levers.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 59 60

Brak uwag

Flowserve PMV D3 Digital Positioner Instrukcja Użytkownika Strona 41