Flowserve Tandem Seal Instrukcja Użytkownika Pobierz pdf (Strona 4)

2.7 Installthecompressionunit45fortheinnersealonthesleeveandlocate

thecollar5inrelationtotheestablishedscribemarkC,thesettingdimen-

siongivenonthesealassemblydrawing.Lockthecollartothesleeveby

tighteningthesetscrewsS.

2.8 Placethesealring3andshaftpackingPfortheinnersealonthesleeve

andinitsproperpositionasshown.(Duraon

shaftpackingshouldbe

installedonthesleeveindividuallyandwithcaretoavoidnicksordamage

thatcouldcausealeak.)

2.9 Placethestationaryinsert2andinsertmounting6fortheinnersealon

thesleeve.

2.10 Wipethefaceofthesealringandstationaryinsertcleanwithalcohol.

2.11 Installthecompressionunit45and/orcollar5fortheoutersealonthe

sleeveandlocatethecollar5attheestablishedscribemarkB.Lockthe

collartothesleevebytighteningthesetscrewsS.

2.12 Placethesealring3AandshaftpackingP1fortheoutersealonthe

sleeveandinitsproperpositionasshown.(Duraon

shaftpackingshould

beinstalledonthesleeveindividuallyandwithcaretoavoidnicksordam-

agethatcouldcausealeak.)

2.13 Wipethefaceofthesealringandstationaryinsertcleanwithalcohol.

Note:Iftheoutersealismountedontheshaftratherthanontheshaftsleeve,it

willbenecessarytosubstitutethefollowinginstallationinstructionsforthe

above:

 2.11A Placetheoutersealring3AandshaftpackingP1ontheshaftandin

 itsproperposition.(Duraon

shaftpackingshouldbeinstalled 

 individuallyandwithcaretoavoidnicksanddamagethatcouldcausea

 leak.)

 2.12A Wipethefaceofthesealringandinsertcleanwithalcohol.

 2.13A Installthecompressionunit45and/orcollar5fortheoutersealon 

 theshaftandlocatethecollarattheestablishedscribemarkB.Lock 

 thecollartotheshaftbytighteningthesetscrewsS.Thenplacethe 

 insertholderIHovertheshaftandintoitsproperpositioninthegland 

 ringasshownonthesealassemblydrawing.

2.14 Whileplacingthesleeveintoitsproperpositionovertheshaft,positionthe

innerstationaryinsert2intotheinsertholderIH,makingsuretoalignthe

insertholdingpinwiththeslotorholeintheinsertholderifoneisincluded.

®RegisteredTrademarkofFlowserveCorporation

1 2 3 4 5 6 7 8

Brak uwag

Flowserve Tandem Seal Instrukcja Użytkownika Strona 4