Flowserve BUSwitch with Foundation Fieldbus Communications P Instrukcja Użytkownika Pobierz pdf (Strona 16)

AXENIM0048-01 (Firmware Rev. Nov. 12 99) (AUTO-48) 11/01 Page 16 of 16

ation, Springville, UT

Flowserve Corporation 1350 South Mountain Springs Parkway Phone: 801 489 2233

Flow Control Division Springville, Utah 84663 Facsimile: 801 489 2228

Automation Business Unit www.flowserve.com Email: [email protected]

Automax Valve Automation Systems

Product S

pecification

18 CHANNEL 1 for DI-1

2 for DI-2

3 for DI-3

4 for DI-4

The number of the logical hardware channel that is connected to this I/O

block. This information defines the transducer to be used going to or

from the physical world.

19 FSTATE_TIME The time in seconds from detection of fault of the output block remote

setpoint to the output action of the block output if the condition still

exists.

20 FSTATE_VAL_D The preset discrete SP_D value to use when fault occurs. This value will

be used if the I/O option Fault State to value is selected.

21 BKCAL_OUT_D The output value and status provided to an upstream discrete block.

This information is used to provide bumpless transfer to closed loop

control.

22 RCAS_IN_D Target setpoint and status provided by a supervisory Host to a discrete

control or output block.

23 SHED_OPT *** Defines action to be taken on remote control device timeout.

24 RCAS_OUT_D Block setpoint and status provided to a supervisory Host for back

calculation and to allow action to be taken under limiting conditions or

mode change.

25 UPDATE_EVT This alert is generated by any change to the static data.

26 BLOCK_ALM The block alarm is used for all configuration, hardware, and connection

failure or system problems in the block. The cause of the alert is entered

in the subcode field. The first alert to become active will set the Active

status in the Status attribute. As soon as the Unreported status is

cleared by the alert reporting task, another block alert may be reported

without clearing the Active status, if the subcode has changed.

*** = NormalShed_NormalReturn

1 2 ... 11 12 13 14 15 16

Brak uwag

Flowserve BUSwitch with Foundation Fieldbus Communications P Instrukcja Użytkownika Strona 16